Make sure that the chalk line crosses the first working line at an angle of 90 . Place the number of parquet boards from the center point to one wall, connecting ridges and grooves. If the last panel should be cut by more than half, move the line back on half tile. This will equalize notches on opposite walls. When laying parquet boards in the hallway or corridor Use the following method. Repel a chalk line on the basis of the mid-point of the two end walls. Lay flooring dry on the line to one of the walls, if necessary, move the line to avoid clipping tiles more than half the width, as explained above.
Trowel, apply a sufficient amount of glue under the 3.1 initial shield. Spread a thin layer of adhesive V-shaped scraper, keeping it at an angle of 45 . Clean the grooves of each parquet board, before I install it. Put a shield on the glue so that one of its corners coincide with the intersecting chalk lines. Hold the shield on the glue. Continue laying boards, urging ridges in grooves. Line up the shields tapping on them a rubber mallet or hammer through the conventional soft liner.
Some difficulties usually causes reupload parquet boards near the wall. If you want to trim the boards, put the tile on the last fixed number, aligning their edges. Place a third board on top to one side of it rested against the bar attached to the wall thickness of 50 mm. Mark a line on the opposite side. Cut the stacked shield on the line. Check to keep the film does not interfere with the joint, if necessary, remove it. For the fitting of the shield in the corner mark cut line on the panel along one of the two walls. Then move the shield, which must be cut to an adjacent wall, not turning him to draw a line on it was parallel to the wall. Put the marker board to the wall and walk along it, forming a line that crosses another line marked. Note the extra piece, formed by two lines, and trim panel. Once all the boards are stacked, cover them with paint and install baseboards. You can lay the same hardwood boards, to get a smooth picture. And you can use the old method of laying panels - diagonal. In this case, diagonally laid tile premises alternately with different patterns (or different colors). Such a method is no more difficult than usual, but the room gets gaiety.
Trowel, apply a sufficient amount of glue under the 3.1 initial shield. Spread a thin layer of adhesive V-shaped scraper, keeping it at an angle of 45 . Clean the grooves of each parquet board, before I install it. Put a shield on the glue so that one of its corners coincide with the intersecting chalk lines. Hold the shield on the glue. Continue laying boards, urging ridges in grooves. Line up the shields tapping on them a rubber mallet or hammer through the conventional soft liner.
Some difficulties usually causes reupload parquet boards near the wall. If you want to trim the boards, put the tile on the last fixed number, aligning their edges. Place a third board on top to one side of it rested against the bar attached to the wall thickness of 50 mm. Mark a line on the opposite side. Cut the stacked shield on the line. Check to keep the film does not interfere with the joint, if necessary, remove it. For the fitting of the shield in the corner mark cut line on the panel along one of the two walls. Then move the shield, which must be cut to an adjacent wall, not turning him to draw a line on it was parallel to the wall. Put the marker board to the wall and walk along it, forming a line that crosses another line marked. Note the extra piece, formed by two lines, and trim panel. Once all the boards are stacked, cover them with paint and install baseboards. You can lay the same hardwood boards, to get a smooth picture. And you can use the old method of laying panels - diagonal. In this case, diagonally laid tile premises alternately with different patterns (or different colors). Such a method is no more difficult than usual, but the room gets gaiety.
Recent Comments